1.ESI 0.9-6(1-0.9)

Constructional & Electrical Performance Data

ESI 09-6 Issue 5 Section 2 – Induced Voltage Control Cable

Conductors:

0.90mm Tinned annealed copper wire in accordance with BS6360 Class 1.

Insulation:

The conductors are insulated with Polyvinyl Chloride Type 02 to BS7655, uniformly twisted together to form a pair with a maximum lay length of 125mm, and colour coded for identification (See Table 1). Suitable for voltages up to and including 150 Volts (d.c.) and 110 Volts (a.c.)

Cable Formation:

2 pair cables are laid up in quad formation.

5 – 100 pair cables are laid up in layer formation.

Screens

All cables, if required, can incorporate a screen comprising of an aluminium/PETP tape.

The tape screen is in contact with a 0.80mm tinned copper drain wire.

Outer Coverings

Type 1	Unarmoured Multipair Light Current Control cables. Extruded Polyvinyl Chloride sheath to BS7655.
Type 2	Armoured Multipair Light Current Control cables. Extruded Polyvinyl Chloride bedding to BS7655, Galvanised steel wire armour to BS1442 and an extruded Polyvinyl Chloride sheath to BS7655.

Alternative PVC materials producing lower levels of HCL are available on request.

Electrical Characteristics

High Voltage Test
	Collective screens	2000 Volts for 1 minute between each conductors & earth
	Cables without screen	5000 Volts for 1 minute between all conductors & earth
Conductor Resistance		59.34 Ohm/Km Loop @ 20°C (Max)
Insulation Resistance		80 MOhm/Km @ 20°C (Min)

Cable Dimensions & Identification

Type 1 cables (Unarmoured)
Type 2 (Armoured)
Table 1 Identification of pairs